To get you started evaluating the NeoCortec Wireless Mesh Networking Protocol, we have designed an evaluation kit which will take you through a few easy steps to start sending payload data from one PC to another through the network. Once the basic steps have been completed, you can start building your own application: We have designed the evaluation board so that you can easily interface to your favourite host controller.

USB link to a PC with 2 virtual COM ports. An Application Port to be used for sending and receiving payload data. A System Port to be used for setting the configuration parameters as well as uploading new software releases should they become available.

Pin headers allow for easy integration to MCU eval boards or other development boards such as Arduino and similar.

In addition to this, the evaluation boards are equipped with Temperature & Humidity sensor, Potentiometer to generate a analog input signal to the build-in A/D converter. Finally there is a series of LEDs which can easily be connected to the GPIOs of the modules to test the digital outputs.

The evaluation kit comes with a USB stick, which includes PC tools for sending and receiving payload data through the wireless mesh network, and for configuring and updating the software inside the module. The evaluation kit contains 5 pcs of evaluation boards with the NCxxxx modules installed.

Watch the Tutorial Video series

These videos will guide you through using the evaluation kit to get familiar with how to configure and use the NeoMesh technology.
Although the videos are done based on using the evaluation kit, the content is also applicable for other NeoMesh module form factors such as the FeatherWing breakout board or a custom board.

Check out our Wireless Congress demo video

This is how easy it is to build a complete sensor-to-cloud system with NeoMesh: 
We have done a short video presenting a small setup we designed for the Wireless Congress 2019, demonstrating how to use the NeoMesh network for IoT sensor networks and simple actuations.

We invite you to watch the video about how to integrate the NeoMesh wireless module in an application, and how to provide a full connectivity solution from sensor to cloud – and back again. It’s only 4 minutes!

INTERESTED IN KNOWING MORE ABOUT NEOCORTEC? CONTACT US
BY CLICKING THE BUTTON BELOW.

Get in touch with us
Mads Fischer, Account Manager

Follow us on our YouTube Channel

ASK US IN PERSON

    Thank you

    We will contact you shortly.